The
product of the estimable design office of Joubert-Nivelt and
interior design office of O. Flahault Design, the Athena 38 was
conceived to support cruising of all kinds, especially coastal.
Unlike some of the wan predecessors of the big-cat genre, this
catamaran, with soft shaping to its hulls of multifoam
core-fiberglass-resin molds, is easy on the eye-even a bit
seductive.
The Athena, the second smallest of Fountaine Pajot's five-cat
line and introduced some 21/2 years ago, betrays its origins from
the country that in recent years has led the evolution of this
boat type. The Athena 38 will be easy to handle for the owner
couple. Alternatively, as a charter boat, four couples will have
absolute privacy in this symmetrical layout where the cabins are
all in the ends and separated by the head-shower-one in each hull.
The low-aspect, 3-foot-deep keels and adequately powered rig will
provide the level of sailing ability one can now expect from this
type of catamaran.
Thoughtful deck plan
I stepped on board the Athena 38 at the transom, taking the
nonskid steps (noting the handy wash-down freshwater hose on the
inside of the hull) up to the stern, which is basically all
cockpit. It is 10 feet wide with comfortable bench seating rimming
most of the area, providing seating for up to 12 people. The
triangular-shaped table at the port corner, out of way of the
companionway, can comfortably seat six people for moonlit al
fresco dining.
You will find yourself looking for the bows of the boat, which
are not conveniently visible as you stand on the cockpit sole,
though you could peer forward by looking through the large double
patio-type sliding Plexiglas doors and big sweeping saloon
windows. (You can also see all 4 corners from the helm position)
The aft bulkheads of the cabintop structure intrude on some of the
sight lines. There are trade-offs to the big cat luxuries and this
is decidedly one of them. However, it had less impact on my
enjoyment of the boat than I thought it would.
(Note from BYA--these pix are of the prior to 99 model. Latest
model adds a walkway behind the cockpit/traveler.)
At
the bulkhead to starboard is the 20-inch-wide wheel with engine
controls and performance electronics module. The flybridge-type
molded plastic chair places the helmsperson at an unusually high
position, which felt odd at first. But after 20 minutes at the
helm, I realized that despite the fact that I was farther off the
water, I felt closer to the sail dynamics, and this was fine.
Being closer to the foretriangle and having excellent visibility
was empowering, engaging my senses.
The mainsheet leads to a self-tailing Lewmar 44 (as on the boat
I tested; Meissner winches
are also fitted) at the aft starboard end of the crowned cabintop
and at the helmsman's reach. The genoa sheets lead through sheet
stoppers to the primaries, with one being the mainsheet's and the
other at the opposite side of the cabintop. The 111/2-foot-long,
double-ended traveler, just aft of the cockpit, is rigged for
large loads. (Not shown in this old picture is the new walkway
which extends across the full width behind the cockpit and
traveler.)
Halyards
are on the mast, a sturdy deck-stepped extrusion from Z-Spar. The
large, roached, full-batten mainsail, sliding on recirculating
ball-bearing cars, is 538 square feet. This could be a bear to
handle for one person; the designers came up with a neat
contingency solution by positioning the anchor locker windlass in
line with the mast. The main halyard can be led at a fair angle to
the electric windlass (a Lofrans on the boat I tested) so one can
opt to hoist under electric power.
Simplified anchor deployment
The anchor setup is ingenious. The stock of the CQR is sucked
with the chain through the hawsepipe opening just below deck level
at the aft end of the trampoline webbing. The business end stows
outside, tangent to the opening. Dropping anchor is a matter of
releasing the windlass brake. With bridle rove to each bow and
connected by snap shackle to the chain, the anchor stays centered
on the bridle and out at the bows.
The locker, roughly 3 by 3 feet, can also hold sails and
fenders in the segmented area adjacent to the chain locker. Main
deck storage is in the voluminous lazarette under the aft cockpit
seat, where deck gear, running rigging, spares and even diving
gear, including tanks, could fit.
A 10-foot inflatable, hard-bottom or rigid dinghy with outboard
neatly stows from davits cantilevered just behind the cockpit. The
whole thing nestles neatly between the hulls. A multi-purchase
launching system was rigged on the boat I tested, which worked
very well in raising a 10-foot inflatable. For heavier dinghies,
it would be possible to lead the hoist rope to a primary winch.
The boat I tested was fitted out with the reliable ProFurl
headsail furling system. The drum was mounted on the forward beam
below the bobstay. The mainsail, which is loose-footed, hoists and
drops through lazy jacks. Its cover remains attached in the boom
boltrope groove of this radically cocked boom. When the main's up,
the cover stows tightly rolled around its internal battens. When
the main's down and flaked, it's just a matter of tying the
integral bungees and sliding the zipper to the end.
I passed through, not down, to the Athena's saloon, sliding the
sturdy, 5- by 2-foot cockpit door. The area, roughly 13 feet wide
with an average 6-foot-plus headroom, is largely a wide, plush
keyhole settee, with a pedestal-mounted, 4-foot-wide table capable
of seating six to eight people in the center. A navigation area
that includes minichart table with drawer and built-in electronics
console above is basic to a fault, though full-chart navigation
for long hauls can be done on the dining table because heeling
isn't a factor.
On the other hand, the U-shaped galley to starboard reveals a
clever bit of planning. The double, 1-foot-diameter, round
sinks-which, since most dishes and pans are round, was handier
than a square sink-is at the end of the U and is usable from three
sides, with hanging and lower cupboards opening on two sides. The
two-burner nongimbaled stove and oven are just beneath an opening
hatch. The unique wedge-shaped, top-opening icebox must have been
designed with the universal adolescent's perpetual hunger in mind.
There enough space to keep up with a teen's metabolic needs, and
it is accessible from three sides. Saloon finish materials are
mainly vinyl and fabric, with dark, fine-grained wood for the
joinerwork. (New, lighter wood finish now standard.)
Inside
Since there is no "going below" on this sailboat, the
saloon is like a continuation of the cockpit, awash in light.
Window treatment sweeps from the front side of the cabin through
nearly 180 degrees. Its eyebrow shade, expanding to 1 foot, 3
inches of overhang, keeps the greenhouse effect to an absolute
minimum, according to Jim Huber, who has put more than 2,000 miles
on his Athena.
The five-step companionways to the hulls are off to the right
and left at the aft end of the saloon. Athena's designers
obviously understood that light and air were necessary to enhance
these potentially cavernlike accommodations. The four opening
hatches and two side ports per hull do a lot in diminishing this
effect, as does the 6-foot, 3-inch average headroom in the hulls.
Each master cabin, with 6-foot, 4-inch headroom, includes a
dressing area with hanging and shelf storage. The double is quite
large, roughly 4-feet, 9-inches by 6-feet, 6-inches. The forward
cabin, with dressing area and slightly narrower double, is at the
end of the 11-foot-long, brightly lit passageway.
The head compartment is about midway. I felt like I was inside
a capsulelike world that Sen. John Glenn may have known from his
space exploration days. With typical French efficiency, the
telephone-booth-type shower (80 gallons of fresh water) is all
part of a grand fiberglass mold treatment. Its feature point: The
big, heavy-duty Lewmar hatch-an escape hatch in an
emergency-provides a grand view of water rushing past or of
dancing nighttime phosphorescence. The head hatches have been set
into a slightly projected reveal, which, in lieu of the hatch, is
designed to absorb the water pounding when the boat is under way.
With foam placed in the stern and transom and in forward areas,
the Athena is unsinkable. The forepeak area, which is usable for
light stowage, is designed to absorb contact, while the keels have
nonstructural, sacrificial components in case of accidental
grounding. The cockpit drains are elaborate, including a half
dozen or so large drainage holes at the saloon door sill, which
drain directly through the bridgedeck. For extra security, a
hardpack liferaft stows on a special underside bracket at the aft
end of the cockpit.
Moving under sail, power
The twin 18-horsepower Yanmar saildrive diesels purred as we
powered from our slip at Waitemata Marina, in Auckland, New
Zealand. Putting the starboard engine in reverse and port engine
in forward, we spun hard to the right, actually turning within the
Athena's length. With the screws spinning far from the cockpit,
the Athena powered quietly with little vibration at most rpms. The
engines are on beefy mounts in well-insulated wells. The engines
are accessible to all sides by removal of the aft cabin berth
cushion and underlying panel. The Athena pushed along at 71/2
knots on flat water at 2,600 rpms. At this rpm, turning fixed,
two-blade props, the auxiliaries use about 4/10 of a gallon per
hour. Fuel tankage is 40 gallons.
The electrical system runs off two banks of two batteries each,
one for anchor operations, the other for under-way operations. To
ensure that the batteries, with a total of 70 amp-hours, don't
flatten out, the two are separate, though in an emergency they
could be connected through a crossover key. To prevent the
windlass from using up the battery power, the port engine must be
running while the windlass is in use.
With sails set, the Athena took off-though nearly imperceptibly
at first. I watched the speedo jump to 10 knots as we sailed on a
beam reach across the Hauraki Gulf (future ballpark for the
America's Cup contestants). There was only slight heel and, when
the puffs hit, we watched the speed instead of the heel angle. I
took Tikitiboo-as this brand-new Athena was named-to close hauled.
She tracked firmly, taking the puffs in stride while tacking at
close to 40 degrees. In the dying breezes that we later
encountered, she did not perform as well. But under chute, she
maintained her sweet ways. And even when the wind increased with
gusts of 25 and 30, she was still well-mannered, even though
slightly overcanvassed.
I spent five days on this Athena. This is a cruising cat
that provides a superior level of sailing and cruising comfort. I
found the boat to be just about everything a cruiser could be in
the way of comfort and privacy. The Athena at anchor or sitting on
the bottom becomes like a raft, ideal for sunbathing and diving.
At a reasonable price, the Athena is a huge amount of boat. All
you need add is the windlass, bimini, autopilot-and sun.
LOA 38.05', Beam 20.66', Draft 3.1', Displacement 11,000 lbs.,
Sail Area (main and genoa) 914 sq. ft.